Energy response on Retro-fitting your Home

Follow up from Nigel Gerdes on Retro-fitting your Home. Heat pump system performance has improved over the last couple of years. IMHO I felt Bill Gethin’s  figures presented at the Nov 2023 talk was a little too pessimistic and were underselling what a good heat pump installation can do. That would be a shame if it put anybody off from considering the switch to a heat pump. The revised £7500 grant can now made an install quite competitive with a gas boiler replacement. As a bonus being able to have the gas meter removed and the supply capped off takes one down from dual fuel standing charges to just electricity!

Here is a link to a YouTube video with an exceptionally clear journey to sufficient knowledge to make the right decisions to install a heat pump on micro-bore piping that gives good results. The house owner is an excellent presenter and gives a very easy to follow account. I like the way he sorted out the wheat from the chaff to find a suitable contractor. It might help somebody who views it to grow in confidence and move forward once they have done any insulation improvements that are at reasonable cost and acceptable disruption. It presents clear evidence that:

A buffer tank should be avoided, and if there is insufficient water volume in the heating loop then a volumiser should be added. A volumiser is a tank added in parallel to the main loop. In contrast a buffer tank is much more complex and as shown a source of inefficiency.
Micro-bore can be made to work well providing and the video does not make this very clear the primary distribution from the boiler is on 22 or better 28mm pipework. In others words only the pipes adjacent to the radiators are micro-bore.  A 100% micro-bore system might not support the flow rates required without incurring large pumping losses.
The open energy monitor system looks the best I have seen and is well worth the money.
The heat pump must be sized down to avoid excessive cycling. Only contractors that have done a proper design would have the confidence to do this. Bad contractors would over size the heat pump as is done with gas boilers with the consequence of poorer efficiency.
The trick as described  to avoid a buffer tank is to have a set of radiators that are always on. This provides sufficient load for the heat pump.
Use anti-frost valves instead of anti-freeze in the loop.
BWCE have this useful Green Open Homes BANES 2023 report here (and this is their review of 2023) Don’t forget: as the weather gets colder your boiler works harder so needs to operate at maximum efficiency.  Lower the flow temperature of your combi boiler and save money and gas use. Know how here